Now that I had finished the print design I created my repeat. This is how I did it.
I used the ruler to mark half way lines on an A4 sized page.
I then duplicated and distributed my design on the centre, making sure the guidlines were covered.
I then merged the layers together.
The next step was to cut each quater of the page and arrange them on a new page as shown below.
I filled the centre spaces using the original print design until there were no white spaces left. I then decreased it's size to fit a quater of a page and then defined it as a pattern. This is what it looked like.
I then duplicated and distributed my design on the centre, making sure the guidlines were covered.
I then merged the layers together.
The next step was to cut each quater of the page and arrange them on a new page as shown below.
I filled the centre spaces using the original print design until there were no white spaces left. I then decreased it's size to fit a quater of a page and then defined it as a pattern. This is what it looked like.
And this is what it finally looked like when I filled the page with the pattern repeat.
No comments:
Post a Comment